Dell PowerEdge M600 - Manual (Page 138)

138
Installing Blade Components
HT Bridge Card (Service Only)
An HT (hypertransport) bridge card must be installed in the third and fourth
CPU sockets on the PowerEdge M805 system board.
Consequently, if you replace the system board, you must transfer the HT
bridge cards to the replacement planar.
Removing an HT Bridge Card
CAUTION:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Remove the blade. "Removing a Blade" on page 96.
2 Open the blade. See "Opening the Blade" on page 100.
3 Pull the socket-release lever straight up until the bridge card is released
from the socket. See Figure 3-22.
4 Open the processor shield and then lift the card out of the socket.