Dell Precision 220 - Manual (Page 83)

Hard-Disk Drive
Selecting Hard-Disk Drive causes the system to attempt to boot first from the hard-disk drive and then from the next device in the boot sequence
list.
IDE CD-ROM Device
Selecting IDE CD-ROM Device causes the system to try booting from the CD-ROM drive first. If it does not find a CD in the drive, the system tries
to boot from the next device in the boot sequence list.
MBA
Selecting MBA causes the system to prompt you to press at the Dell logo screen during boot. A menu then appears that allows you
to select PXE, RPL, BootP, or NetWare as the active boot mode. If a boot routine is not available from the network server, the system tries to
boot from the next device in the boot sequence list.
CPU ID
CPU ID provides the manufacturer's identification code(s) for the installed microprocessor(s). If you have two microprocessors installed, both
should have the same identification code.
CPU Speed
CPU Speed indicates the processor speed at which your system boots.
Press the left- or right-arrow key to toggle the CPU Speed option between the resident microprocessor's rated speed (the default) and a lower
compatibility speed, which lets you accommodate speed-sensitive application programs. A change to this option takes effect immediately
(rebooting the system is not required).
To toggle between the rated processor speed and the compatibility speed while the system is running in real mode, press <\>. (For
keyboards that do not use American English, press <#>.)
Diskette Drive A and Diskette Drive B
Diskette Drive A and Diskette Drive B identify the type of diskette drives installed in your computer. With the standard cabling configuration,
Diskette Drive A (the boot diskette drive) is the 3.5-inch diskette drive installed in the top externally accessible drive bay; Diskette Drive B is a
second diskette drive installed in any of the lower externally accessible drive bays.
The Diskette Drive A and Diskette Drive B options have the following possible settings:
l 5.25 Inch, 360 KB
l 5.25 Inch, 1.2 MB
l 3.5 Inch, 720 KB
l 3.5 Inch, 1.44 MB
l Not Installed
Integrated Devices
Integrated Devices configures the following devices integrated with the system board:
l Sound
l Network Interface Controller
l Mouse Port
l Serial Port 1 and Serial Port 2
l Parallel Port
NOTE: Tape drives are not reflected in the Diskette Drive A and Diskette Drive B options. For example, if you have a single diskette
drive and a tape drive attached to the diskette/tape drive interface cable, set Diskette Drive A to match the characteristics of the
diskette drive and set Diskette Drive B to Not Installed.