Dell PowerVault DP600 - Manual (Page 63)

63
To optimize performance
1. On the Summary page, click optimize performance.
2. In the Optimize Performance dialog box, on the Network tab, select Enable on-the-
wire compression to reduce the size of the data transfer and increase CPU utilization on
the DPM server and the protected servers.
3. In the Start protection jobs box, select the time of hour you want the protection job to
start to balance the loads of synchronization jobs across protection groups, thus avoiding
possible performance degradation.
4. On the Consistency Check tab, select Schedule daily consistency check, and then
select the start time and maximum duration of the consistency check to prevent DPM
from interfering with regular business use of your protected servers.
5. Click OK.
Creating the Protection Group
Before you create the protection group, review the tasks that DPM is set to perform. The tasks
are based on the options that you specified while performing the steps in the wizard.
To optimize the performance of the protection group, on the Summary page, click the optimize
performance link to launch the Optimize Performance dialog box.
To create the protection group
1. On the Summary page, review the tasks that DPM is set to perform to create the
protection group and then click Create Group.
When the creation process is complete, DPM displays a confirmation page where you
can view the results of creating the protection group task.
2. On the Confirmation Page, click Close.
Optional Configuration Tasks
You can enable optional System Center Data Protection Manager (DPM) 2007 features during
initial configuration or at any time after you deploy DPM 2007. The topics in this section describe
the optional features that you can configure.
In This Section
•
Enabling End-User Recovery