Dell PowerVault DP600 - Manual (Page 54)

54
Specifying Exchange Protection Options
If you selected an Exchange Server data source to protect, the Specify Exchange Protection
Options page appears. You use this page to specify whether you want to check the integrity of
the Exchange Server databases and to select the cluster node that you want to protect.
To specify Exchange protection options
1. On the Specify Exchange Protection Options page, select the Run Eseutil to check
data integrity check box to check the integrity of the Exchange Server databases.
The Exchange Server Database Utilities (Eseutil.exe) must be installed on the protected
server for tape-based protection. For disk-based protection, you must also install
Eseutil.exe on the DPM server. For more information about Eseutil.exe, see Eseutil
(http://go.microsoft.com/fwlink/?LinkId=83451).
2. Select the type of node you want to protect for Cluster Continuous Replication (CCR)
Exchange Server:
• Protect active node. Select this option to select the active node as the node that
DPM will protect.
• Protect passive node. Select this option to select the active node as the node that
DPM will protect.
• Protect only the specified node. Select this option to specify the node that you
want DPM to protect, and then select the protection node from the drop-down list.
3. Click Next.
Selecting a Name and Protection Method for
the Protection Group
After you select the data you want to protect, you select your protection method. You can select
short-term protection by using either disk or tape, or you can select long-term protection using
only tape.
To select a name and protection method
1. On the Select Data Protection Method page, in the Protection group name box,
accept the default name or type a new name for the protection group.
Note