Dell PowerVault DP600 User Manual

Page 26

Server that you want to use and the appropriate administrator credentials, and then

click Next.

Note

If SQL Server Reporting Services is installed on the remote SQL Server,

DPM Setup will use that Reporting Service. If SQL Server Reporting Services

is not installed on the remote computer running SQL Server, you must install

and configure the service on the remote computer running SQL Server

before continuing with DPM Setup.

11. On the Security Settings page, specify and confirm a strong password for the restricted

MICROSOFT$DPM$Acct and DPMR$ local user accounts, and then

click Next.

For security purposes, DPM runs SQL Server and the SQL Server Agent service under

the MICROSOFT$DPM$Acct account, which DPM Setup creates during DPM

installation. To securely generate reports, DPM creates the DPMR$

account.

A strong password is typically defined as a password that is at least six characters long,

does not contain all or part of the user’s account name, and contains at least three of the

following four categories of characters: uppercase characters, lowercase characters,

base 10 digits, and symbols (such as !, @, #).

Note

The password that you specify for these accounts does not expire.

12. On the Microsoft Update Opt-In page, specify if you want to sign up for the Microsoft

Update service, and then click Next.

You can change your Microsoft Update opt-in decision at any time after you install

DPM 2007. To change your Microsoft Update opt-in decision, see the

(http://go.microsoft.com/fwlink/?LinkId=74122).

13. On the Customer Experience Improvement Program page, specify if you want to enlist

in the Customer Experience Improvement Program (CEIP), and then click Next.

14. On the Summary of Settings page, review the summary of installation settings. To

install DPM using the specified settings, click Install. To change the settings, click Back.

After the installation is complete, the Installation page displays the installation status.

15. Click Close, and then restart the computer to incorporate all of the changes made by

DPM Setup.

Note

This restart is necessary to load the volume filter that DPM uses to track and transfer

block level changes between DPM and the computers it protects, or between the

primary and secondary DPM servers.