Dell PowerVault DP600 - Manual (Page 35)

35
2. Select the <computer name>\MS$DPM2007$ database, and then click Connect.
3. Expand Databases, right-click the DPMDB database, and then click Delete.
4. Click Yes to confirm the deletion.
To install DPM
• For information about installing DPM, see
Installing DPM 2007 .
To restore the DPM database using the DpmSync tool
1. From the command prompt, type DpmSync -sync.
2. After the new installation is complete and the database is restored, in DPM Administrator
Console, in the Monitoring task area, check for protection jobs that failed during the
repair operation. Manually restart any failed jobs.
3. After you restart the failed jobs you must perform a consistency check for all data
sources. For instructions on how to perform a manual consistency check, in DPM 2007
Help, see "How to synchronize a replica".
Uninstalling DPM 2007
When you uninstall System Center Data Protection Manager (DPM) 2007, you can choose
whether to remove or retain your existing recovery points and replicas. To continue accessing
recovery points on the DPM server after you uninstall DPM, you must choose to retain your data
protection configuration when you uninstall DPM.
Important
If you plan to retain your existing data protection configuration after uninstalling DPM,
disable end-user recovery on the DPM server and run synchronization jobs for each data
source in your protection groups before you start the uninstallation. These steps help
ensure that users to whom you deny access to files on the server cannot access the
replicas of those files on the DPM server.
Uninstall DPM 2007
Setup uninstalls only the DPM application. Setup does not remove the prerequisite software,
protection agents, user settings, and Dr. Watson for Windows Server 2008 operating system. You
must uninstall the DPM application, the prerequisite software, and the protection agents in the
following order: