Step 3: uninstalling the protection agents, Step 4: uninstalling the user settings, Step 5: uninstalling dr. watson – Dell PowerVault DP600 User Manual
Page 37: Configuring dpm 2007

37
4. Under Currently installed programs, select the prerequisite software, and then
click Remove.
5. Click Yes, to confirm the deletion.
To uninstall PowerShell 1.0 on Windows Server 2008
1. Click Start, point to Administrative Tools, and then click Server Manager.
2. Expand Server Manager to the Features node, and then select Features.
3. In the Features pane, click Remove Features.
4. Clear the Windows PowerShell checkbox and complete the uninstall.
• Single Instance Storage (SIS)
To uninstall SIS on Windows Server 2008
1. From an administrator command prompt, type start /w ocsetup.exe SIS-
Limited/uninstall/quiet/norestart.
2. After the uninstall is complete, you must restart the computer.
Step 3: Uninstalling the protection agents
If you want to use DPM Administrator Console to uninstall protection agents deployed on
protected servers, you must do so before you start uninstalling DPM. Alternatively, you can
use Add or Remove Programs to uninstall protection agents from the servers locally after you
complete uninstalling DPM.
Step 4: Uninstalling the User settings
To remove user settings, after you complete uninstalling DPM, delete the folder named:
System Data Protection Manager 2007
Step 5: Uninstalling Dr. Watson
To uninstall Dr. Watson on Windows Server 2008, from the command prompt type one of the
following commands:
• 32-bit operating system: msiexec /x {95120000-00B9-0409-0000-0000000FF1CE}
• 64-bit operating system: msiexec /x {95120000-00B9-0409-1000-0000000FF1CE}
Configuring DPM 2007
After you install System Center Data Protection Manager (DPM) 2007, you must perform a series
of required configuration tasks before you can start protecting your data. You can also configure