Dell PowerEdge 2800 - Manual (Page 54)

If two SCSI cables are connected, note their relative locations.
4. Unlock the expansion-card cage cam lever and rotate it to the vertical position. See Figure 6 -12 .
5. Lift the expansion-card cage from the chassis.
Figure 6-12. Installing and Removing the Expansion-Card Cage
Installing the Expansion-Card Cage
1. Reinstall any expansion card(s). See " Installing an Expansion Card ."
2. Raise the expansion-card cage cam lever to a vertical position. See Figure 6 -12 .
3. Fit the guide rail on the back of the expansion-card cage into the corresponding notch in the system chassis, then lower the expansion-card cage into
the system chassis. See
Figure 6 -12 .
4. As you lower the cage into place, the two alignment pins fit into the slots in the side of the system.
5. Carefully close the cam lever to lock the card cage into place.
6. Reconnect the SCSI data cable(s) to the SCSI connector(s) on the riser card or SCSI controller. See Figure A -4 .
7. Close the system. See " Closing the System " in "Troubleshooting Your System."
Installing an Expansion Card
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against
electrostatic discharge.
NOTICE: If two SCSI data cables were connected to the riser card or SCSI controller, reinstall them in the same relative locations.
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against
electrostatic discharge.