Dell PowerEdge R910 User Manual
Page 54
54
About Your System
PCIe Training
Error: Expected
Link Width is
x
,
Actual Link Width
is
y
.
Faulty or improperly installed
PCIe card in the specified
slot.
Reseat the PCIe card in the
specified slot number. See
Cards" on page 189. If the
problem persists, see
Plug & Play
Configuration
Error.
Error encountered in
initializing PCIe device;
faulty system board.
Install the NVRAM_CLR
jumper in the clear position
(pins 1 and 3) and reboot the
system. See Figure 6-1 for
jumper location. If the
problem persists, see
Read fault
Requested sector
not found.
The operating system cannot
read from the hard drive,
optical drive, or USB device,
the system could not find a
particular sector on the disk,
or the requested sector is
defective.
Replace the optical medium,
USB medium or device.
Ensure that the SAS
backplane, USB, or SATA
cables are properly
connected. See
Drive" on page 186 for the
appropriate drive(s) installed
in your system.
SATA Port
x
device
not found.
There is no device connected
to the specified SATA port.
Information only.
Message
Causes
Corrective Actions
book.book Page 54 Tuesday, December 4, 2012 3:11 PM