Dell PowerEdge R910 - Manual (Page 122)

122 Installing System Components
Integrated NIC Hardware Key
TCP/IP Offload Engine (TOE) and iSCSI are enabled by default on the
system. The integrated NIC hardware key is reserved for future use.
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
NOTE: TOE operating system support and the Microsoft ® scalable network pack
are required for TOE functionality.
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Open the system. See "Opening the System" on page 89.
3 Locate the iSCSI_KEY connector on the system board. See Figure 6-1.
4 Insert the NIC hardware key into the connector onto the board. See
Figure 3-18.
book.book Page 122 Tuesday, December 4, 2012 3:11 PM