Raid battery, Removing a raid battery – Dell PowerEdge R910 User Manual
Page 145
Installing System Components
145
RAID Battery
The information in this section applies only to systems with the optional
PERC controller card.
Removing a RAID Battery
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 89.
3 If applicable, remove the memory-riser blanks. See "Removing a Memory-
4 Remove the memory risers. See "Removing a Memory Riser" on page 100.
5 Remove the memory-riser guide. See "Removing the Memory-Riser Guide"
6 Pull back gently on the right edge of the battery carrier and lift the RAID
battery from the battery carrier. See Figure 3-27.
7 Disconnect the RAID battery cable from the RAID battery.
book.book Page 145 Tuesday, December 4, 2012 3:11 PM