beautypg.com

3 remove the jumper plug from the password jumper, 4 close the system, 8 install the jumper plug on the password jumper – Dell PowerEdge R910 User Manual

Page 202: 9 lower the memory module shroud, 10 close the system, 12 assign a new system and/or setup password

background image

202

Jumpers and Connectors

3 Remove the jumper plug from the password jumper.

See Figure 6-1 to locate the password jumper (labeled "PWRD_EN") on

the system board.

4 Close the system.
5 Reconnect your system and peripherals to their electrical outlets, and turn

on the system.
The existing passwords are not disabled (erased) until the system boots

with the password jumper plug removed. However, before you assign a new

system and/or setup password, you must install the jumper plug.

NOTE:

If you assign a new system and/or setup password with the jumper plug

still removed, the system disables the new password(s) the next time it boots.

6 Turn off the system, including any attached peripherals, and disconnect

the system from the electrical outlet.

7 Open the system. See "Closing the System" on page 90.
8 Install the jumper plug on the password jumper.
9 Lower the memory module shroud.

10 Close the system.
11 Reconnect your system and peripherals to their electrical outlets, and turn

on the system.

12 Assign a new system and/or setup password.

To assign a new password using the System Setup program, see "Assigning

a System Password" on page 79.

book.book Page 202 Tuesday, December 4, 2012 3:11 PM