Dell POWEREDGE R515 User Manual
Page 30
30
About Your System
E1410 System Fatal
Error
detected.
Specified processor has an
internal error. The error
may or may not have
been caused by
the processor.
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
E1414 CPU # temp
exceeding
range.
Check CPU
heatsink.
Specified processor is out
of acceptable
temperature range.
Ensure that the processor
heat sinks are properly
installed. See
E1418 CPU # not
detected.
Check CPU
is seated
properly.
Specified processor is
missing or bad,
and the system is in an
unsupported
configuration.
Ensure that the specified
processor is properly
installed. See
E141C Unsupported
CPU config.
Check CPU or
BIOS revision.
Processors are in an
unsupported
configuration.
Ensure that your
processors match and
conform to the type
described in the processor
technical specifications
outlined in your system’s
Getting Started Guide.
E141F CPU # protocol
error. Power
cycle AC.
The system BIOS
has reported a processor
protocol error.
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
Code
Text
Causes
Corrective Actions
book.book Page 30 Tuesday, August 24, 2010 1:47 PM