Dell Latitude XT (Late 2007) - Manual (Page 197)

Adding and Replacing Parts 197
Installing the Wireless Switch
1 Set the wireless switch into the base.
2 Tighten the M2.5 x 5-mm screw. Slide the wireless On/Off switch to
confirm that the board is connected to the base correctly. If the switch is
too tight, then the alignment of the board to the base shifted during
assembly. Loosen the M2.5 x 5-mm screw and confirm that the alignment
of the bracket hole to the base hole is concentric.
3 Install any Mini-Cards (see "Installing a Mini-Card" on page 173).
4 Install the keyboard (see "Installing the Keyboard" on page 177).
5 Install the display assembly (see "Installing the Display Assembly" on
page 182).
6 Install the hinge cover (see "Installing the Hinge Cover" on page 175).
book.book Page 197 Tuesday, May 13, 2008 5:03 PM