Installing the fan, Pen and whip antenna assembly, Removing the pen and whip antenna assembly – Dell Latitude XT (Late 2007) User Manual
Page 193

Adding and Replacing Parts
193
Installing the Fan
1 Seat the fan into the system board, and tighten the four M2 x 3-mm screw
using a #0 Phillips screwdriver.
2 Connect the fan cable to the system board.
3 Install the system board (see "Installing the System Board" on page 191).
4 Install the palm rest (see "Installing the Palm Rest" on page 189).
5 Install the keyboard (see "Installing the Keyboard" on page 177).
6 Install the display assembly (see "Installing the Display Assembly" on
7 Install the hinge cover (see "Installing the Hinge Cover" on page 175).
8 Install any Mini-Cards (see "Installing a Mini-Card" on page 173).
Pen and Whip Antenna Assembly
CAUTION:
Before performing the following procedures, follow the safety
instructions in your
Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching a connector on the back panel of the
Tablet-PC.
NOTICE:
To avoid damaging the system board, you must remove the main battery
before you begin working inside the Tablet-PC.
Removing the Pen and Whip Antenna Assembly
1 Follow the procedures in "Before You Begin" on page 155.
2 Remove the hinge cover (see "Removing the Hinge Cover" on page 174).
3 Remove the display assembly (see "Removing the Display Assembly" on
4 Remove the keyboard (see "Removing the Keyboard" on page 176).
1
M2 x 3-mm screws (4)
2
fan
3
fan cable connector
book.book Page 193 Tuesday, May 13, 2008 5:03 PM