Dell XPS/Dimension XPS Gen 2 - Manual (Page 86)

86
Removing and Installing Parts
www
.dell.com | support.dell.com
4 Press inward on the two tabs on the sides of the drive, slide the drive upward, and remove it
from the floppy-drive bay.
Installing a Floppy Drive
1 Follow the instructions in "Before You Begin" on page 68.
2 Open the computer cover (see page 70).
3 If you are replacing a drive and the new drive does not have the bracket rails attached, remove
the rails from the old drive by removing the two screws that secure each rail to the drive.
Attach the bracket to the new drive by aligning the screw holes on the drive with the screw
holes on the bracket rails and then inserting and tightening all four screws (two screws on
each rail). See the diagram on page 83.
4 Gently slide the drive into place until the tabs securely click into position.
floppy-drive cable
power cable
tabs (2)
floppy drive
T2310bk2.book Page 86 Thursday, February 5, 2004 10:00 AM