Dell XPS/Dimension XPS Gen 2 - Manual (Page 102)

102
Removing and Installing Parts
www
.dell.com | support.dell.com
6 Insert the new battery into the socket with the side labeled "+" facing up, and snap the
battery into place.
7 Close the computer cover.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into
the computer.
8 Connect your computer and devices to electrical outlets, and turn them on.
9 Enter system setup (see page 109) and restore the settings you recorded in step 1.
10 Properly dispose of the old battery (see page 11).
Closing the Computer Cover
1 Ensure that all cables are connected, and fold cables out of the way.
2 Ensure that no tools or extra parts are left inside the computer.
3 Close the computer cover:
a Pivot the cover down and into position.
b Press down on the cover to close it.
c Once the cover is closed, slide the cover latch release to the right until the latch clicks
into place.
battery socket
(BATTERY)
battery
T2310bk2.book Page 102 Thursday, February 5, 2004 10:00 AM