Dell XPS/Dimension XPS Gen 2 - Manual (Page 85)

Removing and Installing Parts
85
7 Connect the power and hard-drive cables to the drive.
8 Check all connectors to be certain that they are properly cabled and firmly seated.
9 Close the computer cover (see page 70).
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into
the computer.
10 Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software
required for drive operation.
Floppy Drive
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions
page 9.
Removing a Floppy Drive
1 Follow the instructions in "Before You Begin" on page 68.
2 Open the computer cover (see page 70).
3 Disconnect the power and floppy-drive cables from the back of the floppy drive.
T2310bk2.book Page 85 Thursday, February 5, 2004 10:00 AM