Dell XPS/Dimension XPS Gen 2 - Manual (Page 75)

Removing and Installing Parts
75
Installing Memory
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions on
page 9.
1 Follow the instructions in "Before You Begin" on page 68.
2 Open the computer cover (see page 70).
3 Lay the computer on its side so that the system board is on the bottom of the inside of the
computer.
4 If necessary, remove a memory module:
a Press out the securing clip at each end of the memory module connector.
b Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it
from the connector.
5 To insert a module, press out the securing clip at each end of the memory module connector.
securing clips (2)
connector
memory connector closest
to processor
T2310bk2.book Page 75 Thursday, February 5, 2004 10:00 AM