Canon EOS 10D User Manual
Page 169
169
Ref
erence
13
On-screen Messages
Cannot print!
The image was captured by another camera or in an incompatible
format. Or the image has been edited with a personal computer.
Description
Message
Could not print **
images
The image was captured by another camera or it has been edited with
a personal computer and printing was attempted in accordance with
the DPOF setting for ** prints.
** images remaining
Since the printing with the DPOF setting was interrupted, ** prints still
remain to be printed.
Cannot trim
The image was captured by another camera or it is in an incompatible
format. Or the image has been edited with a personal computer. Such
images cannot be trimmed.
When a BJ printer capable of direct printing is connected to the camera, the camera’s LCD
monitor may display any of the messages below. If any of these messages are displayed,
check the error code on the BJ printer’s operation panel and refer to the BJ printer’s manual for
the error description.
No paper
The paper has not been inserted properly or there is no paper. Or
there is a problem with the paper feed operation.
Description
Message
No ink
There is no ink tank or the ink tank has no ink.
Paper jam
The paper jammed during printing.
Printer in use
Printing from the personal computer or the memory card in the printer
is in progress. When the printing ends, the images in the camera’s CF
card will start printing automatically.
Printer warming up
The printer is preparing for printing. When the printer is ready, printing
will start automatically.
No printhead
There is no print head.
Printer cover open
Close the printer’s front cover.
Media type error
Paper that the printer cannot use has been selected. Select a paper
that can be used with the [Style] setting on the camera’s direct
printing screen.
Paper lever error
Set the paper spacing lever to the proper position.
Low ink level
The ink tank must be replaced soon. Keep a new ink tank on hand. To
resume printing, select [Resume] on the error message screen.
Battery level is too
low.
Direct printing was not possible, because the camera battery level is
too low.