Canon EOS 10D - Manual (Page 167)

167
Ref
erence
13
On-screen Messages
The messages displayed on the LCD monitor are as follows.
Busy The camera is either processing the data or writing the captured
image onto the CF card. Wait until it is finished.
Description Message
The camera is reading the image in the CF card. Wait until it is
finished.
There is no CF card. Load a proper CF card into the camera.
There is a problem with the CF card. Replace the CF card.
Since the CF card is full, no more images can be recorded or no more
printing instructions can be saved.
Loading image...
No CF card
CF card error
CF card full
The CF card has no displayable images. Either take a shot and save it
or replace the CF card with one that has images. No Image
The image is not displayable because it is larger than 4064 x 2704
pixels. Image too large
The JPEG image is not displayable because it is incompatible. Incompatible JPEG
format
The image data cannot be displayed because it is damaged. Corrupted data
The image cannot be rotated because it was captured by another
camera, captured in a different format, or edited with a personal
computer. Cannot rotate
The image is not displayable because it was captured in an unknown
format (recording format of another camera manufacturer, etc.). Unidentified Image
The image cannot be erased because it is erase-protected. To delete
the image, first disable the erase protection. Protected!
Printing of a non-JPEG image was attempted. Printing is not possible.
Specification of an image captured by another camera or an image
edited with a personal computer was attempted with Custom WB
image selection. The white balance data cannot be loaded. Unselectable image
The printing specification was too many. The printing cannot be
specified above this number. Too many marks
The printing specification could not be saved. Cannot complete!
The image could not be magnified because it was captured by another
camera or it is in an incompatible format or it has been edited with a
personal computer. Cannot magnify!
There is not enough battery power for shooting or image playback.
Replace the battery. Change the battery
pack
The image is not displayable because it is a CCDRAW image captured
by another camera. CCDRAW