Compex Technologies WPE54 - Manual (Page 108)

Chapter 5 Further Configuration
107
5.7.3 To enable Parallel Broadband
Before enabling the Parallel Broadband feature, verify whether:
•
Each of the access points is correctly configured to connect to its specific
broadband Internet account.
•
You need to enable DHCP on all of the access points in Parallel
broadband. It is recommended that each of the access points leases IP in a
non-overlapping IP address pool.
•
All of the access points are interconnected in a chain manner using WDS
as illustrated in the section on WLAN Basic Setup.
•
Each of the access points is running in Gateway mode with the Parallel
Broadband option enabled.
Enable Parallel Broadband
Click on Parallel Broadband from the CONFIGURATION menu.
By default the Parallel
Broadband feature is disabled.
Enable the Parallel Broadband
Status.
Click on
Apply button.
Repeat this for the other access
points in your network.