Great Plains V-300F Operator Manual - Manual (Page 67)

6/29/2006 148-057M
65 Monitor Operation
Summary of Program Modes 1 – 3
Most settings do not need to be accessed during normal operation, unless perhaps the instrument is transferred
to another tractor/implement. Default values shown in [brackets].
Mode 1 Mode 2 Mode 3
Operating Mode
Select channel, press
and hold ‘+1’ to enter
Power on while hold-
ing ‘+1’ to enter mode.
Use same key to
select channel
Power on while
holding ‘Stop/HA’ for
10 seconds to enter
mode. Use same
key to select
channel
Channel 1
Forward Speed
(Km/h)
Speed sensor fac-
tor & autocal
Default: 2m/pulse
Forward speed
alarm
Default: 1 (on)
No function
Channel 2
Area x 2
(Ha)
Working width
Default: 4.000 meters
Metric/imperial selec-
tion
Default: Metric (Ha)
Grand total area
(Ha)
Channel 3 Tramline
Tramline sequence
Default: SY04
Tramline on/off
Default: 1 (on)
Tramline on/off
Default: 1 (on)
Channel 4
Fertilizer shaft speed
(RPM)
Low alarm speed
Default: 0rpm
Fertilizer shaft alarm
delay
Default: 10
Fertilizer shaft ppr
Default: 3.000
Channel 5
Seed shaft speed
(RPM)
Low alarm speed
Default: 0rpm
Seed shaft alarm
delay
Default: 10
Seed shaft ppr
Default: 3.000
Channel 6 Hopper Alarm
Hopper alarm on/off
Default: 1 (on)
No function No function