Great Plains V-300F Operator Manual - Manual (Page 47)

6/29/2006 148-057M
45 Monitor Operation
Channel Indicator
The indicator is used to indicate the channel to which the information on the display relates.
Normal Display Mode
The instrument has a normal display mode displaying six work functions. Select a channel by pressing the
button once or more.
When the drill is moving, the selected channel is displayed for 10 seconds before defaulting back to the tramline
bout display channel. When the drill is stationary the instrument will flash between forward speed and
the Tramline channel. If the tramline option is turned off, the instrument will simply default to the Forward Speed
channel.
Programming Modes
There are 3 programming modes with various calibration factors and default settings.
Many of these settings are made on installation and do not normally need to be changed unless the instrument
is switched onto a different drill. These settings are appended to the back of this section. The operator does not
normally need to refer to them.
Units
The instrument can be set to display metric or imperial units. To see which is selected, select either the forward
speed channel or the area channel , then press and hold the button.
Either the top row of horizontal segments or the bottom row of horizontal segments will briefly display, indicating
the units selected.
NOTE: ‘MET’ and ‘IMP’ are printed on the instrument front panel on most instrument variants.