Great Plains V-300F Operator Manual - Manual (Page 19)

6/29/2006 148-057M
17 Preparation and Setup
8. Align connector in bottom of outer casing.
NOTE: BE SURE CONNECTOR AND CASING ARE
PROPERLY ALIGNED, OTHERWISE CASING
WILL NOT FIT CORRECTLY.
9. Tighten screws securing wires and metal bar in
place.
10. Replace top of outer casing. Insert and tighten
screws removed in Step 3.
11. Slide black rubber end piece over the end of the
outer casing securing the wires.
Hitching Tractor to Implement
!
DANGER
You may be severely injured or killed by being crushed be-
tween the tractor and drill. Do not stand or place any part
of your body between drill and moving tractor. Stop trac-
tor engine and set park brake before installing pins.
Refer to Figure 5
1. Place hitch weldment (1) over ball swivel on
hitch tongue (2). Hold hitch weldment in place by
inserting spacer tube (3) through hitch clevis and
ball swivel.
2. Back tractor up to hitch and bolt hitch weldment
to tractor drawbar using 1-by-10-inch bolt (4),
large flat washer (5), lock washer (6), and nut
(7).
3. Use 3/4-by-9-inch bolt (8) to bolt hitch weldment
through its slotted hole and onto secondary hole
of tractor drawbar. Install a 3/4-inch flat washer
(9) next to top slotted hole and fasten with a lock
washer (10) and nut (11). Tighten both bolts.
4. Securely attach safety chain to tractor-drawbar
frame.
17215
Figure 5
Drawbar Assembly
Refer to Figure 4
7. Attach wires to connector using the terninal number in-
dicators on the back of the connector and the table be-
low.
Conductor
Identification
Wire
Color
Terminal
Number
Circuit
Wht White 3 Ground
Yel Yellow 1 Left Blinker
Grn Green 4 Right Blinker
Brn Brown 6 Tail Lamps
Figure 4
Back of Connector
23255