Great Plains V-300F Operator Manual - Manual (Page 52)

V-300, V-300F
148-057M 6/29/2006
50
Set Implement Width
In order for the instrument to accumulate area correctly, the imple-
ment working width must be programmed. The units are either in
inches if the instrument is set for imperial units, or in meters if it is
set for metric units.
1. Select the channel.
2. HOLD to enter program mode 1.
The top/bottom horizontal segments indicating metric/imperial
units are displayed briefly before the calibration factor ap-
pears. Continue holding the button and…
3. PRESS to select the digit or decimal point to change.
4. HOLD to change the selected digit (or move the
decimal point).
5. RELEASE to select the next digit and repeat as
above, otherwise simply release both buttons. The instrument
will then return to the normal display mode.
The V300 has a working width of 3 meters.
2 1
3 4
View Implement Width
Set Implement Width