ClearOne XAP TH2 - Manual (Page 21)

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
The XAP TH2 has four basic functions: make a call, answer a call, disconnect a call,
and mute. This chapter explains how to perform these functions with the TH2 unit
and a telephone handset (optional) and with the Dial interface in G-Ware. You can
also use touch panels and custom control devices.
To answer a call
Depending on how you have configured your XAP TH2, an incoming call can ring on
the telephone set connected to the XAP TH2, the receive output, and pass a serial
ring to the control device. An incoming call will also cause the front panel On LED
[C] to flash. You can answer the call in one of two ways:
• Press the On button [D] on either the front panel or on your remote control.
This will route the call through the XAP TH2 to the XAP 800. The green On
LED [C] will light. The red Off LED [F] will extinguish. Upon connection,
the XAP TH2 automatically adjusts to the line conditions.
• Answer the call by picking up the telephone handset and talking to your
party over the telephone.
To make and disconnect a call
1. Call the party using your handset.
2. After the other party has answered, route the call through the XAP TH2 by
pressing the On button [D]. The On LED [C] will light and the XAP TH2 will
take control of the call, disabling the telephone set. You may now safely hang
up the handset without disconnecting your call.
If using an external controller, it is not necessary to press the On button [D].
The DIAL serial port command automatically engages the XAP TH2. See
Serial Commands, page 28.
CHAPTER 4: Operation
Using the XAP TH2
Figure 4.1. XAP TH2 front-panel controls
If you have turned on
Audible Ring Indication
(see page 14), you will
hear a ringing sound from the
receive channel when a call
comes in.
✍ ✍