ClearOne XAP TH2 - Manual (Page 11)

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
The XAP TH2 is designed for easy installation and setup. All connections are made
through rear-panel connectors. This section provides instructions on installing the
units in the rack and making initial connections, assigning device ID numbers, and
creating an expansion bus (E-bus) network.
The diagram below illustrates the typical connections that are made when
adding a XAP TH2 to a XAP 800.
CHAPTER 2: Installation
Figure 2.1. System diagram
Hardware Setup
Connecting the unit
Refer to XAP TH2 rear-panel drawing on the following page. Each connector is
numbered for easy identification.
1. Place the unit in the rack and attach it securely. XAP TH2 models are
designed for installation in a standard 19-inch equipment rack.
2. Connect your telephone line from the wall jack to the RJ-11C Line jack [B].