ClearOne XAP TH2 - Manual (Page 16)

Configuration ~ G-Ware 12
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
2. If you have already established a connection with the site, the Device
ID will be assigned. If you are working offline, select the Device ID that
matches the ID you assigned the unit via the back-panel DIP switches.
Device IDs ensure the software will sync up with the proper unit when there
are multiple TH2s on a network.
3. Adjust the Meter Refresh rate as necessary. The default rate is 50ms.
4. Select the country where this product is being used from the
Country Code list.
Warning: The country code must be set correctly to ensure that the unit
operates properly when connected to the telco network and complies with
the country’s telco requirements. Changing this code to a country other
than the intended country of operation might cause the XAP TH2 to be
non-compliant.
5. Click the Comm tab. The Baud Rate and Flow Control settings are changed
using the Site Properties window. Select the Serial Echo and Serial Mode
you want to use.
Serial Echo enables the unit to echo back the commands you send over the
E-bus network. Serial Mode determines the format (binary or text) in which
the commands return over the E-bus network. The default setting when
G-Ware is connected to a unit is binary. When the unit is disconnected, the
default is text.
6. Select Use Modem if a modem will be used with the unit.
7. Click the Security tab to enter a Modem Password. This password will be
required for all connections made to the RS-232 port whether it be modem,
direct connection to PC, or AMX touch panel.
8. Click OK to save settings and close the Unit Properties window.
You will need to repeat this process for all XAP TH2 units on your network.
Figure 3.2. Unit Properties General tab
Figure 3.3. Unit Properties Comm tab
Figure 3.4. Unit Properties Security tab