beautypg.com

Section 2: introduction, 01 how to use this manual, 02 equipment identification – Tweco 175i Transtig User Manual

Page 13: 03 receipt of equipment, Transmig 175i

background image

TRANSMIG 175i

Manual 0-5143

2-1

INTRODUCTION

SECTION 2:

INTRODUCTION

2.02 Equipment Identification

The unit’s identification number (specification or

part number), model, and serial number usually ap-

pear on a nameplate attached to the control panel. In

some cases, the nameplate may be attached to the

rear panel. Equipment which does not have a control

panel such as gun and cable assemblies is identified

only by the specification or part number printed on

the shipping container. Record these numbers on the

bottom of page i for future reference.

2.03 Receipt Of Equipment

When you receive the equipment, check it against

the invoice to make sure it is complete and inspect

the equipment for possible damage due to shipping.

If there is any damage, notify the carrier immediately

to file a claim. Furnish complete information concern-

ing damage claims or shipping errors to the location

in your area listed in the inside back cover of this

manual.
Include all equipment identification numbers as

described above along with a full description of the

parts in error.
Move the equipment to the installation site before

un-crating the unit. Use care to avoid damaging the

equipment when using bars, hammers, etc., to un-

crate the unit.

2.01 How To Use This Manual

To ensure safe operation, read the entire manual,

including the chapter on safety instructions and

warnings.
Throughout this manual, the words WARNING,

CAUTION, and NOTE may appear. Pay particular at-

tention to the information provided under these head-

ings. These special annotations are easily recognized

as follows:

!

WARNING

A WARNING gives information regarding

possible personal injury.

CAUTION

A CAUTION refers to possible equipment

damage.

NOTE

A NOTE offers helpful information con-

cerning certain operating procedures.

Additional copies of this manual may be purchased by

contacting Cigweld at the address and phone number

for your location listed in the inside back cover of this

manual. Include the Owner’s Manual number and

equipment identification numbers.