Tweco 175i Transtig User Manual
175i operating manual, Transmig, Multi process welding inverter
Table of contents
Document Outline
- 0-5143-CCr
- SECTION 1:ARC WELDING SAFETY INSTRUCTIONS AND WARNINGS
- SECTION 2:INTRODUCTION
- SECTION 3:INSTALLATION, OPERATION AND SETUP
- 3.01 Environment
- 3.02 Location
- 3.03 Ventilation
- 3.04 Mains Supply Voltage Requirements
- 3.05 Electromagnetic Compatibility
- 3.06 Transmig 175i Power Source Controls, Indicators and Features
- 3.07 Attaching the Tweco Professional Fusion Mig Torch (Euro)
- 3.08 Installing Minispool (100mm diameter)
- 3.09 Installing Handispool (200mm diameter)
- 3.10 Inserting Wire into the Wire Feed Mechanism
- 3.11 Feed Roller Pressure Adjustment
- 3.12 Changing the Feed Roll
- 3.13 Wire Reel Brake
- 3.14 Shielding Gas Regulator Operating Instructions
- 3.15 Setup for MIG (GMAW) Welding with Gas Shielded Mig Wire
- 3.16 Setup for MIG (GMAW) Welding with Gasless Mig Wire
- 3.17 Setup for TIG (GTAW) Welding
- 3.18 Setup for Manual Arc (MMAW) Welding
- SECTION 4:BASIC WELDING GUIDE
- SECTION 5:POWER SOURCE PROBLEMS AND ROUTINE SERVICE REQUIREMENTS
- SECTION 6:KEY SPARE PARTS
- APPENDIX: TRANSMIG 175i CIRCUIT DIAGRAM
- CIGWELD - LIMITED WARRANTY TERMS
- TERMS OF WARRANTY – JULY 2010
- WARRANTY SCHEDULE – JULY 2010
- GLOBAL CUSTOMER SERVICE CONTACT INFORMATION
- SECTION 1: ARC WELDING SAFETY INSTRUCTIONS AND WARNINGS
- SECTION 2: INTRODUCTION
- SECTION 3: INSTALLATION, OPERATION AND SETUP
- 3.01 Environment
- 3.02 Location
- 3.03 Ventilation
- 3.04 Mains Supply Voltage Requirements
- 3.05 Electromagnetic Compatibility
- 3.06 Transmig 175i Power Source Controls, Indicators and Features
- 3.07 Attaching the Tweco Professional Fusion Mig Torch (Euro)
- 3.08 Installing Minispool (100mm diameter)
- 3.09 Installing Handispool (200mm diameter)
- 3.10 Inserting Wire into the Wire Feed Mechanism
- 3.11 Feed Roller Pressure Adjustment
- 3.13 Wire Reel Brake
- 3.14 Shielding Gas Regulator Operating Instructions
- 3.15 Setup for MIG (GMAW) Welding with Gas Shielded Mig Wire
- 3.16 Setup for MIG (GMAW) Welding with Gasless Mig Wire
- 3.17 Setup for TIG (GTAW) Welding
- 3.18 Setup for Manual Arc (MMAW) Welding
- SECTION 4: BASIC WELDING GUIDE
- SECTION 5: POWER SOURCE PROBLEMS AND ROUTINE SERVICE REQUIREMENTS
- AP0-5143-APENDIX
- CIGWELD - LIMITED WARRANTY TERMS
- TERMS OF WARRANTY - JULY 2010
- WARRANTY SCHEDULE - JULY 2010
- GLOBAL CUSTOMER SERVICE CONTACT INFORMATION