Tweco 400 Ultra-Cut XT Plasma Cutting System - Manual (Page 83)

ULTRA-CUT 100 XT/200 XT/300 XT/400 XT
Manual 0-5297 OPERATION 4-5
4.05 TSC-3000 Selecting New Process
Art # A -09160
Select process by # (2) or by
name (3).
If by name, first select
process type; best cut,
fastest, MAX Pierce, etc.
Then press
To accept
a ance to Torch
onsumables. (
).
3
Material
Scroll to select,
Thic ness
Scroll to select,
Accept a ance ( ).
S T P S S
2
M
S T MAT IA , T I S S
S T P SS M
onfirm the liste torch
consumables are installe in
the torch.
o to T settin s for
cuttin ( ).
Select ne stan ar process by material; thic ness; ampera e ( )
or enter process # usin pop up number pa (2).
P SS M IT
o you are rea y to start cuttin . isplaye Amps eman is the output current
settin , not the actual current.
As soon as Start is applie Process Monitor sho s output olta e, as pressures,
status of Start, to Mo e an as n si nals. ere you can to le bet een Plasma
Mar in ith the selecte consumables an cuttin .
To le bet een ut
Mar in settin s ( ).
Procee to Process Monitor
( ).
T S MA S T Settin s ( uttin )
T Settin s (Mar in )