beautypg.com

SoundOff Signal Predator2 WS Light Suction Cup Mount User Manual

Windshield model, Warning

background image

WARNING

: Warning devices are strictly

regulated and governed by Federal, State and
Municipal ordinances. These devices shall be
used ONLY on approved vehicles. It is the sole
responsibility of the user of these devices to
ensure compliance.

WARNING

: Warning devices are strictly

regulated and governed by Federal, State and
Municipal ordinances. These devices shall be
used ONLY on approved vehicles. It is the sole
responsibility of the user of these devices to
ensure compliance.

WINDSHIELD MODEL

ASSEMBLY INSTRUCTIONS

EP2SWS+(x) [single] EP2DWS+(x) [dual]

MOUNTING WINDSHIELD BRACKET

Important Note: DO NOT OVER TIGHTEN
NUTS as this could cause permanent damage
to bracket. DO NOT use an Aerobic thread
locking fluid. They are NOT compatible with
plastic used for the bracket.
1. Attach the bottom half of the Windshield
bracket to the PREDATOR II first. Align to
proper position and hand tighten the mounting
nuts plus 1/8 turn. (see #1)
2. Attach the three suction cups to the top half
of the Windshield mounting bracket using the
truss head self tapping screws provided in
kit. (see #2)

Important: DO NOT

OVERTIGHTEN

SCREWS!

3. Align the top and bottom half of the bracket
as shown (see #3). Connect the two halves
together using the 4mm nut, bolt and flat
washer provided. Loosely tighten nut and
bolt.
4. Install Windshield shroud following the
"Windshield Shroud Instructions".
5. Hold PREDATOR II in place and adjust the
angle of the bracket to the proper position.
Proper position is when light is level
(horizontal). HAND TIGHTEN the adjustment
screws plus 1/8 of a turn.
6. Hold PREDATOR II in desired location and
press the three suction cups firmly against the
windshield.

OPERATING INSTRUCTIONS

1. Plug the PREDATOR II power

cord into the vehicle cigarette
lighter plug.

Note:

The

PREDATOR

II

protection fuse is located in the
nose of the cigarette lighter plug
(not shown). Unscrew metal
retaining ring to expose fuse.

2. To activate the PREDATOR II

push the red button (#4) on the
left (driver's side) of the unit.

3. To deactivate the PREDATOR II

push and HOLD the red button
until unit turns off.

4. The PREDATOR II can generate

33 different light patterns (see
table at right). To change light
patterns, momentarily push the
red button, A, while the unit is
operating. Each push of the red
button will advance the
PREDATOR II to the next
pattern. When desired pattern is
reached release red button. That
pattern will be stored in the
PREDATOR II memory and will
automatically come up every
time the unit is turned on.

Replacement Parts / Accessories

PPRDWBRKT

PREDATOR Windshield Bracket w/ Suction Cups

Optional Mounting Brackets

PZBKT248

Z Bracket for Mounting to Headliner - Permanent Mount

PPRDGMBRKT

PREDATOR Permanent Glass Mount Kit w/ Adhesive

NOTE: Illustration shows Dual Windshield Model - EP2DWS+(x)

3

1

4

4

2

Check for proper installation:

1. Shroud is trimmed correctly.
2. All suction cups are pressed to

windshield as firmly as possible.

3. Unit is mounted horizontally.

HORIZONTAL

FIRM

TRIM

!

WARNING

This product contains high intensity LED

devices. To prevent eye damage, DO NOT

stare into light beam at close range.

EP2xWS+(x) 4.08