CommScope ATC200-LITE-USB - Manual (Page 98)

Section 14–Changing the Electrical Downtilt-Single SmartBeam™ ATC200-LITE-USB Teletilt ® RET System
14-2 October 2014 Bulletin 639536 • Revision L
4. The Set Actuator Position screen will appear (Figure 14-2).
Note, all parameters that can be configured are displayed on this screen. This information may
be used as a reference to help determine the new tilt setting. However, configuration items
cannot be changed from this screen. All changes to configuration items must be done with the
Configuration screen as discussed in Section 10.
5. Enter the new angle in the New Tilt text entry field to change the electrical downtilt. Note that
the allowed range of angle values is displayed in the Min Electrical Tilt and Max Electrical Tilt
fields in the top part of the screen. Any downtilt angle within this range may be entered. Downtilt
is controllable with a precision of 0.1 degree. Other axes may use whole degree precision
(Figure 14-2).
Examples: Five degrees downtilt may be entered as 5 or 5.0. A downtilt of five and one-half
degrees would be entered as 5.5.
Figure 14-2. Configuring New Electrical Downtilt Setting.
1.
ngle
may
be entered with the precision of 0.1 degree (Ex: 5.0 or 5.5).
Progress
Display.