CommScope ATC200-LITE-USB User Manual

Page 8

Table of Contents

ATC200-LITE-USB Teletilt

RET System

October

2014

Bulletin 639536 • Revision L

October

2014

Bulletin 639536 • Revision L

Part 4 – Operating Instructions for Standard Antennas

with Attached Actuators

Section 5 Actuator Protocol Mode Switching....................................................5-1

5.0 Protocol Mode switching for ATM3 devices .............................................................. 5-1
5.0.1 Using AISG Reset Option Tools ............................................................................... 5-1
5.0.2 Switching a Single ATM200-002 to Ericsson Protocol .............................................. 5-4
5.1 Protocol Mode switching for AccuRET devices ........................................................ 5-6

Section 6 Device Configuration ........................................................................6-1

Section 7 Changing the Electrical Downtilt on a Single Antenna ......................7-1

Section 8 Changing the Electrical Downtilt on a Group of Antennas ................8-1

Part 5 – Operating Instructions for Antennas with Multiple

Integrated Actuators

Section 9 Switching Operating Modes for Multiple Integrated Actuators ........9-1

Section 10 Device Configuration for Antennas with Multiple Integrated

Actuators .....................................................................................10-1

Section 11 Adjusting the Electrical Downtilt on a Single Antenna Equipped

with Multiple Integrated Actuators ...............................................11-1

Section 12 Adjusting the Electrical Downtilt on a Group of Antennas Equipped

with Multiple Integrated Actuators ...............................................12-1

Part 6 – Operating Instructions for SmartBeam

Antennas

Section 13 Device Configuration with SmartBeam™ Antennas ......................13-1

Section 14 Changing the Electrical Downtilt on a Single SmartBeam™
Antenna

........................................................................................14-1

Section 15 Changing the Boresight (Pan) on a Single SmartBeam™
Antenna

........................................................................................15-1

Section 16 Changing the Beamwidth (Fan) on a Single SmartBeam

..................

Antenna

........................................................................................16-1

Section 17 Changing the Electrical Downtilt on a Group of SmartBeam™
Antennas

.......................................................................................17-1