CommScope ATC200-LITE-USB - Manual (Page 83)

Bulletin 639536 • Revision L October 2014 11-1
Section 11
Adjusting the Electrical Downtilt on a Single
Antenna Equipped with Multiple Integrated
Actuators
The electrical downtilt may be adjusted on any device that is addressed, configured, and whose cur-
rent state does not prevent antenna movement. Examples where movement is prevented include
devices that are not responding to commands from the program, devices that are in the middle of a
move or configuration change, and devices that are experiencing a mechanical malfunction.
Each antenna with multiple integrated actuators has several tilt actuators that are denoted by the
suffixes ‘t1’, ‘t2’, etc.
1. Switch to RET Device view by selecting ‘Show RETs’ from the drop down list below the Device
Information list.
2. From the Device Information list, click on the device to be moved (Figure 11-1).
3. Click Move Selected at the bottom of the screen (Figure 11-1).
Figure 11-1. Selecting Device for Electrical Downtilt Adjustment.
2. Click Move Selected.