CommScope ATC200-LITE-USB User Manual

Page 61

ATC200-LITE-USB Teletilt

RET System

Section 6–Device Conﬁguration

Bulletin 639536 • Revision L

October

2014

6-4

this ﬁeld is not required, if no installation date has been saved on the actuator the program

will suggest the current date as the default. If the current date is used, it will be saved on the

actuator when the Conﬁgure button is activated. Alternately, the suggested date may be

erased and a new date entered, or the ﬁeld may be left blank. When a date is entered, it

must be formatted as MM/DD/YY as shown in Figure 6-2 (A forward slash character placed

between the month and day and a forward slash character placed between the day and

year) i.e., July 7, 2008 would be typed as 07/07/08.

• The installer’s ID must be 1 to 5 characters in length with any combination of letters
and

numbers.

• Values speciﬁed for the frequency band, sector, technology, location, and mechanical tilt are

used for reference only and have no direct affect upon the actuator/antenna that is being

conﬁgured.

•

Frequency band (AISG 1.1)/Operating Band (AISG 2.0) value can have multiple values set.
Click on the drop down arrow in the list to open the multi selection list. Make selection by click-
ing on the check box for the relevant frequency. Click outside the list or press ESC key to close
the list (Figure 6-3).

Figure 6-3. Multiple Frequency/Operating Band Selection

8. After verifying the accuracy of all ﬁelds, click Conﬁgure. Alternately, the user may go back and

edit/change any of the selections made or click the Cancel button to quit this process without
making any changes to the actuator’s current conﬁguration.

9. After

the

Conﬁgure button has been activated, the user will be prompted to conﬁrm changes

to the actuator are to be applied. Click Yes to proceed with the changes, or click No to return to
the conﬁguration screen (Figure 6-4).

When proceeding to make changes, the selected settings will be sent to the actuator and stored
there. The main screen will change the status of this device to Conﬁguring to indicate that new
settings are being sent to the actuator. The status icon is yellow while the conﬁguration data is
changing.

1. Click to open the

down list.

2. Click on check box to

frequencies.

selected frequency
band names.

3. Click outside the list or