CommScope ATC200-LITE-USB - Manual (Page 66)

Section 7–Changing the Electrical Downtilt-Single ATC200-LITE-USB Teletilt ® RET System
7-3 October 2014 Bulletin 639536 • Revision L
7. You will be notified when movement is complete (Figure 7-3).
If for any reason the move failed to reach the new tilt angle specified, you will be notified of the
failure.
8. At the successful completion of an antenna movement, the Current Tilt field will update to
show the new tilt angle and the New Tilt text entry box will be cleared in preparation for the next
move (Figure 7-4). At this point, you may click on the Close button to exit this screen and return
to the main screen. Alternately, this process may be repeated to further adjust the tilt position
or to reapply changes where movement had previously failed, such as a temporary mechanical
jam.
9. After closing the Set Actuator Position screen, the main screen will show the new actuator
position setting in the Device Information list.
After all movements have been made and you are ready to end the program session, a report
can be saved to a file for future reference. Settings can be stored to a file for future reference
using the Site Reports function. See Section 18.
Figure 7-3. Electrical Tilt Adjustment Complete.
Figure 7-4. New Electrical Tilt Displays in Current Tilt Field.
Click OK.
becomes current Click Close.