CommScope ATC200-LITE-USB - Manual (Page 69)

ATC200-LITE-USB Teletilt ® RET System Section 8–Changing the Electrical Downtilt-Group
Bulletin 639536 • Revision L October 2014 8-2
4. From the Set Electrical Tilt for Sector screen, notice that the selected device is highlighted
and displayed in the box labeled Antennas Included In Move. This box displays a list of all
devices that will be included in the sector move. Initially, this box contains only the antenna
that was selected from the main screen. All of the current configuration settings for this device,
including its current tilt, are displayed on this screen (Figure 8-2).
Other devices that have the same sector ID, minimum tilt, and maximum tilt are listed in the
box labeled Additional Compatible Antennas. The devices in this box may be included in the
move by moving one or more of them from this box to the box on the left.
5. To help determine if additional antennas could be included in the group move, click on each
model to be considered to display their individual settings. Each time a device is selected, its
settings will be displayed on the screen.
6. After the settings have been examined for each candidate, the devices determined to be includ-
ed in the move may be added to the group in either of the following methods.
• Select the device and click Add.
• Double click on the device to immediately move it to the Antennas Included In Move box
(Figure
8-2).
Figure 8-2. Adding Devices to be Included in the Sector Move.
2. Click Add
models with same Min
included in the move.