CommScope ATC200-LITE-USB - Manual (Page 64)

7-1 October 2014 Bulletin 639536 • Revision L
Section 7
Changing the Electrical Downtilt on a Single
Antenna
The electrical downtilt may be adjusted on any device that is addressed, configured, and whose cur-
rent state does not prevent antenna movement. Examples where movement is prevented include
devices that are not responding to commands from the program, devices that are in the middle of a
move or configuration change, and devices that are experiencing a mechanical malfunction.
Note: Some Teletilt ® actuators might switch to Safety Mode if they are moved repeatedly
from maximum to minimum position without a pause. That safety feature ensures that the
actuator is not damaged from overheating. If the actuator goes into Safety Mode, then the
operator should wait about 60 to 90 seconds while the actuator cools so it is free to move
again.
1. Switch to RET Device view by selecting ‘Show RETs’ from the drop down list below the Device
Information list.
2. From the Device Information list, click on the device to be moved (Figure 7-1).
3. Click Move Selected at the bottom of the screen (Figure 7-1).
Figure 7-1. Selecting Device for Electrical Downtilt Adjustment.
2. Click Move Selected.