CommScope ATC200-LITE-USB User Manual

Page 59

ATC200-LITE-USB Teletilt

RET System

Section 6–Device Conﬁguration

Bulletin 639536 • Revision L

October

2014

6-2

Note the following in Figure 6-2:

• The ID of the device to be conﬁgured is displayed in the title bar of the dialog box.

• Devices that have never been conﬁgured before will display blank ﬁelds for most param-

eters.

•

Actuators that have been factory installed on an antenna are pre-conﬁgured to include the
antenna model number, antenna type, and antenna serial number. The remaining ﬁelds
such as Installation Date, Mechanical Tilt, Bearing, Height, Sector, Location, Oper. Band
(for AISG 2.0 actuators) or Freq. Band (for AISG 1.1 actuators), Technology, Station ID, and
Installer ID will need to be conﬁgured.

• Conﬁguration items marked with an asterisk are required; saving a new conﬁguration will be

disabled if any of these ﬁelds are blank.

• The Installation Date ﬁeld is handled differently from all other conﬁguration items.

Although this ﬁeld is not required, if no installation date has been saved on the actuator, the
program will suggest the current date as the default.

• AISG 2.0 Protocol Mode allows a 32 character Station ID.

Figure 6-2. Device Configuration Screen.

ion data is

e completed.

2. Click