Autocue US 10-11-01 WinCuePro News AvStar Interface - Manual (Page 84)

WINCUEPRO FOR AVSTAR USER GUIDE SCROLL CONTROLS
VERSION 1.30 84  QTV 2001
The General tab is used to set which communications port the multi-button scroll
control is attached to and, if required, set it up for Center Stop Mode. Center Stop
Mode is used if the operator prefers to use the scroll knob to change the direction of
the prompted text rather than/as well as use the FWD/REV button. To enable the
Center Stop Mode, the check box should be checked ( ).
7.5.2 Configuring Scroll Control Buttons
The Buttons tab allows the user to configure each of the buttons individually. The
buttons are pre-configured for use. The standard settings are as shown below: