Autocue US 10-11-01 WinCuePro News AvStar Interface User Manual
Page 82
WINCUEPRO FOR AVSTAR USER GUIDE
SCROLL CONTROLS
VERSION 1.30
82
QTV 2001
The red and black buttons can be configured to perform the desired function. Usually
the red button is used for jumping to the next marker in the current direction and the
black button to change direction. However if you are employing center stop mode the
black button can be used for some other function. Click the down arrow next to the
text box and select the required function from the drop-down list.
Center Stop Mode is used if the operator does not want to use the forward reverse
button to change the direction of the prompted text. To enable Center Stop Mode, the
Center Stop Mode check box should be checked ( ).
7.4.2 Configuring the Scroll Table
Click the Configure IMT End Stop or Center Stop Scroll Table Tab depending on the
mode you are using. The simple serial scroll control sends serial data in the range 0
to 120 to tell WinCue how fast to prompt the text; 0 is stop and 120 is the fastest scroll
rate. This scroll rate is determined by the position of the scroll control knob. If the Stop
Point is set to 60, scroll rates of less than 60 will prompt the text backwards, scroll
rates greater that over 60 will prompt the text forward, and a scroll rate of exactly 60
will stop the text from scrolling. The Stop Zone is a range between 0 and 40 over
which the prompted text does not scroll. If the Stop Point is set to 60 and the Stop