Rockwell Automation 1440-VST02-01RA XM-120 Eccentricity Module - Manual (Page 38)

Publication GMSI10-UM010C-EN-P - May 2010
30 Installing the XM-120 Eccentricity Module
Figure 2.18 Non-contact Sensor to Channel 2 Wiring
Connecting the Remote Relay Reset Signal
If you set the module relay to latching and the relay activates, the relay stays
activated even when the condition that caused the alarm has ended. The
remote relay reset signal enables you to reset your module relay remotely after
you have corrected the alarm condition. This includes latched relays in the
Expansion Relay module when it is attached to the XM-120.
Wire the Remote Relay Reset Signal to the terminal base unit as shown in
Figure 2.19.
TYPICAL WIRING FOR NON-CONTACT SENSOR
TO XM-120 ECCENTRICITY MODULE CHANNEL 2
COM
SIG
-24
Channel 2 Input Signal
-24V DC
1
17
22
Signal Common
21
Jumper ing terminal 21 to
terminal 22 configures
CH 2 buffer for -24V to +9V
(See Table 2.1)
Isolated Sensor Driver
Shield
Shield
Floating
38
TIP
If you set a module relay to latching, make sure that any
linked relays, such as relays in an XM-440 Master Relay
Module, are not configured as latching. When both relays
are set to latching, the relay in each module will have to be
independently reset when necessary.
TIP
You can discretely reset a relay using the serial or remote
configuration tool.