Powerflex 700s control connections – Rockwell Automation 20D PowerFlex 700S/700H Frames 10...14 IP00, NEMA/UL Open Power Structures User Manual
Page 40
40
Rockwell Automation Publication PFLEX-IN020C-EN-P - July 2013
PowerFlex 700S and 700H Frames 10...14 IP00, NEMA/UL Open Power Structures
PowerFlex 700S Control
Connections
Note: For PowerFlex 700H control connections, see PowerFlex 700H Control
Connections on page
34
.
The PowerFlex 700S control uses 24V DC supplied from the Voltage Feedback
board and fiber optic connections supplied from the Voltage Feedback and ASIC
circuit boards, which are located on the power structure. Frame 12 and 14 drives
contain two ASIC boards and two ASIC Feedback boards that supply these
connections.
Refer to figures
25
,
26
and
27
for the location of the Voltage Feedback board.
Refer to the figures
19
,
20
and
21
for the location of the ASIC board(s).
Figure 25 - Frames 10 and 12 Voltage Feedback Board Location
IMPORTANT
It may be necessary to disconnect the control connections during drive
installation and then re-connect according to the instructions in 700S Control
Connections on page
42
.
Power Structure #1
Frame 12 Only