Rockwell Automation 1440-VAD02-01RA XM-123 Aeroderivative Module - Manual (Page 47)

Publication GMSI10-UM003D-EN-P - May 2010
39
A single switch contact can also be shared by multiple XM modules wired in
parallel as shown in Figure 2.29.
Figure 2.29 Typical Multiple XM Modules Remote Relay Reset Signal Connection
Connecting the Setpoint Multiplication Switch
You can configure the module to multiply the alarm setpoints, or inhibit the
alarms during the start-up period. This can be used to avoid alarm conditions
that may occur during startup, for example, when the monitored machine
passes through a critical speed.
Wire the Setpoint Multiplication switch to the terminal base unit as shown in
Figure 2.30.
ATTENTION
The relay reset connections may be different for different
XM modules. Figure 2.29 applies only to the XM-123
module. Refer to the installation instructions for the
module for its terminal assignments.