Rockwell Automation GV3000/SE AC Bookshelf Drive Hardware Ref, Installation, and Troubleshooting - Manual (Page 85)

Compliance with Electromagnetic Compatibility Standards C-1
A
PPENDIX
C
Compliance with Electromagnetic
Compatibility Standards
C.1 Introduction
This appendix provides information on the GV3000/SE Bookshelf drive’s compliance
with European community electromagnetic compatibility standards and covers the
following:
• requirements for standards compliance
• instructions on how the drive must be wired.
The GV3000/SE drives listed on the Declaration of Conformity (DOC) have been
tested and are in compliance with the following standards:
• EN50081-2 (1993)
Electromagnetic compatibility - Generic emission standard
Part 2: Industrial
• EN50082-2 (1995)
Electromagnetic compatibility - Generic immunity standard
Part 2: Industrial
Note that the conformity of the GV3000/SE Bookshelf drive to the above standards
does not guarantee that the entire installation will be in conformance.
Copies of the Declaration of Conformity (DOC) may be obtained by contacting the
Rockwell AutoFax service at 440-646-7777.
C.2 Compliance Requirements
In order for the GV3000/SE Bookshelf drive to conform to the standards listed in
section C.1, the drive must:
• be specified by model number on the DOC.
• have a CE mark. This mark is found on the drive’s certification label.
• include an AC Mains Filter.
• be installed according to the instructions in this appendix.