Rockwell Automation GV3000/SE AC Bookshelf Drive Hardware Ref, Installation, and Troubleshooting - Manual (Page 25)

About the Drive 2-11
2.6.4 Option Board Connector
The flat-ribbon cable connector (X3) on the bottom of the Regulator board is a parallel
bus connection port that provides a means of attaching optional boards such as the
DeviceNet Option board, the RMI board, the AutoMax Network Option board, or
similar boards to the GV3000/SE drive. See figure 2.6. Refer to the appropriate board
instruction manual for more information. Refer to section 2.11 of this manual for more
information on optional drive kits.
2.6.5 Operator Interface Module (OIM) Connector
Flat-ribbon connector X7 provides a means of attaching the optional Operator
Interface Module (OIM). The OIM is available for use as a remote keypad for the drive.
Refer to the Operator Interface Module manual (D2-3342) for more information.
2.7 Keypad/Display
The front panel keypad/display is used to program and operate the drive. See figure
2.10. The four-character display is used to indicate drive parameters, parameter
values, and error codes. The fourteen single LEDs indicate drive status and operating
mode, as well as identify drive outputs whose values are displayed on the
four-character display.
Refer to the GV3000/SE Bookshelf Drive Software Start-Up and Reference manual
(D2-3426) for more information about the keypad/display.
Figure 2.10 – Keypad/Display
5
F W D
R E V
A U T O
M A N
E N T E R
R U N
J O G
P R O G
START
S T O P
R E S E T
RPM
V
A
Hz
kW
TRQ
PASS
RUN
REM
JOG
AUTO
F W D
REV
PROG
Keypad
START Key
Drive Status LEDs
Monitor Mode LEDs
STOP/RESET Key
Display
Password LED