Rockwell Automation GV3000/SE AC Bookshelf Drive Hardware Ref, Installation, and Troubleshooting User Manual

Gv3000/se ac bookshelf drive

background image

GV3000/SE AC Bookshelf Drive

Version 6.06

Hardware Reference, Installation, and Troubleshooting Manual D2-3427-3

Table of contents

Document Outline

GV3000/SE AC Bookshelf Drive Hardware Reference, Installation, and Troubleshooting Manual D2-3427-3
Important User Information
Document Update
Summary of Changes
Table of Contents
List of Figures
List of Tables
Chapter 1 - Introduction
- Related Publications
- Getting Assistance from Reliance Electric
Chapter 2 - About the Drive
- Identifying the Drive
- Understanding the Enclosure Rating: IP20
- 2 to 15 Amp GV3000/SE Bookshelf Drive Component Locations
- 24 to 30 Amp GV3000/SE Bookshelf Drive Component Locations
- 43 Amp GV3000/SE Bookshelf Drive Component Locations
- Regulator Board Description
- Keypad/Display
- Output Relay Terminal Strip
- Internal Braking Transistor
- Optional Internal AC Mains Filter
- Optional Equipment
Chapter 3 - Planning Before Installing
- General Requirements for the Installation Site
- Wiring Requirements for the Drive
Chapter 4 - Mounting the Drive, Grounding, and Finding Wire Routing Locations
- Mounting the Drive
- Determining Input, Motor Output, Ground, and Control Wire Routing for the Drive
- Grounding the Drive
Chapter 5 - Installing Input Power Wiring
- Installing Transformers and Reactors (Optional)
- Installing Fuses for Branch Circuit Protection
- Installing a Required External/Separate Input Disconnect
- Installing Power Wiring from the AC Input Line to the Drive’s Power Terminals
Chapter 6 - Installing Output Power Wiring
- Installing Output Contactors (Optional)
- Installing Mechanical Motor Overload Protection (Optional)
- Installing Output Wiring from the Drive Output Terminals to the Motor
Chapter 7 - Wiring the Regulator Board Terminal Strip and the Output Relay Terminal Strip
- Stopping the Drive
- Wiring the Encoder Feedback Device (FVC Regulation Only)
- Wiring the Signal and Control I/O
Chapter 8 - Wiring Optional User-Supplied Braking Resistors
- Installation Guidelines
- Selecting a Braking Resistor
- Installing the Braking Resistor
Chapter 9 - Completing the Installation
- Checking the Installation
- Powering Up After Installation Is Complete
Chapter 10 - Troubleshooting the Drive
- Test Equipment Needed To Troubleshoot
- Drive Alarms and Faults
- Verifying That DC Bus Capacitors Are Discharged
- Checking Out the Drive with Input Power Off
- Checking the Cooling Fans
- Replacement Parts
Appendix A - Technical Specifications
Appendix B - Compliance with Machinery Safety Standard EN 60204-1:1992
Appendix C - Compliance with Electromagnetic Compatibility Standards
- Introduction
- Compliance Requirements
- Wiring Practices
Index
Back Cover /Publication D2-3427-3 August 2013