Rockwell Automation WebPak 3000 DC Drives Hardware Reference, Installation and Troubleshooting - Manual (Page 9)

C
HAPTER
1
Introduction to the WebPak3000 Drive 1-1
Introduction to the WebPak 3000 Drive
This section provides specifications and a description of the WebPak 3000 Drive.
1.1 Store the Drive
After receipt inspection, repack the drive in its original shipping container until ready for installation.
To ensure satisfactory operation at startup and to maintain warranty coverage, store the drive as follows:
• In its original shipping container in a clean, dry, safe place.
• In an ambient temperature that does not exceed 65 ° C (149 ° F) or go below -30 ° C (-22 ° F).
• Within a relative humidity range of 5 to 95% without condensation.
• Away from a corrosive atmosphere. In harsh environments, cover the shipping/storage
container.
• At an altitude of less than 3,000 meters (10,000 ft.) above sea level.
1.2 Drive Identification Nameplate
The WebPak 3000 drive has a nameplate on the right side of the carrier that identifies the drive by its
specific Hardware and Software Part Numbers and applicable AC input power and DC output power
data. Refer to this nameplate example.
All communication concerning this product should refer to the appropriate Part Number information.
The technical power information should be referenced to verify proper power application.
P.N. -EQUIPMENT 849.17.43 A SER. NO.
P.N. -VERSION EU I/M 49‘1359
TYPE WP3000-S6R-F1600-60-AN-FC
S/W VERSION 1.0
US M/N US I/M H/W US I/M S/W
INPUT 575 VAC 3PH 60 Hz, 1360 A
OUTPUT 0 -600 VDC, 1600 A
SHORT CIRCUIT SYM RMS RATING 85 kA
ENCLOSURE IP00
CHARACTER OF LOAD M
MADE IN SWITZERLAND BY ROCKWELL AUTOMATION AG, DIERIKON
CE, UL, CUL
Figure 1.1 - Sample WebPak 3000 Nameplate